It appears you don't have support to open PDFs in this web browser. To view this file, Open with your PDF reader
Abstract
In this study, the polymer blends based on natural rubber latex and acrylic resin was prepared. It was then utilized as a binder for paint. The blending ratios between natural rubber latex and acrylic resin were varied from 30/70, 40/60, 50/50, 60/40, and 70/30 (w/w) where the natural rubber latex was pre-vulcanized prior to be blended with acrylic resin. The investigation was monitored through the physical and mechanical properties of the blends. Highest tensile strength and elongation at break were found at the blending ratio at 30/70 (w/w) of natural rubber latex and acrylic resin. This may be attributed to the compatibility between elastic phase of the natural rubber and hard phase of acrylic resin. When adding higher ratio of natural rubber latex, the tensile strength and elongation at break dropped continuously, indicating inhomogeneity of these two phases. To confirm the compatibility of the blend at 30/70 (w/w), the gel content was also observed. It is clear that such blend completely dissolved in non-polar solvent unlike other blending ratios. Therefore, this blending ratio is highly suggested and appropriate for applying as binder for paint.
You have requested "on-the-fly" machine translation of selected content from our databases. This functionality is provided solely for your convenience and is in no way intended to replace human translation. Show full disclaimer
Neither ProQuest nor its licensors make any representations or warranties with respect to the translations. The translations are automatically generated "AS IS" and "AS AVAILABLE" and are not retained in our systems. PROQUEST AND ITS LICENSORS SPECIFICALLY DISCLAIM ANY AND ALL EXPRESS OR IMPLIED WARRANTIES, INCLUDING WITHOUT LIMITATION, ANY WARRANTIES FOR AVAILABILITY, ACCURACY, TIMELINESS, COMPLETENESS, NON-INFRINGMENT, MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. Your use of the translations is subject to all use restrictions contained in your Electronic Products License Agreement and by using the translation functionality you agree to forgo any and all claims against ProQuest or its licensors for your use of the translation functionality and any output derived there from. Hide full disclaimer
Details
1 Research and Development of Halal Products, Faculty of Science and Technology, Fatoni University, Pattani, 94160, Thailand.
2 Industrial Metrology and Testing Service Centre, Thailand Institute of Scientific and Technological Research, Patumthani, Bangkok 12120, Thailand.
3 Department of Rubber Technology and Polymer Science, Faculty of Science and Technology, Prince of Songkla University, Pattani Campus, 94000, Thailand.